| |
|
| Instructions: |
|
| Step 1. |
Open design program and select checked frame and add a light blue background to the interior of frame. Add images as desired and print two on one sheet of card stock. |
| Step 2. |
Laminate and cut out.
|
| Step 3. |
Cut a piece of foam core that is slightly smaller than the laminated images. |
| Step 4. |
Mark the aluminum pipe at 4, 5, 6, 7 & 8 inches. Place in vise and saw the different sizes of chimes. Then place each chime in vise and drill a hole to hang the chime
|
| Step 5. |
Used sander to deburr the holes and cut ends.
|
| Step 6. |
Punch two holes in the foam core for the hanger, tie ribbon and tape the tails of the ribbon to the foam core.
|
| Step 7. |
Mark the holes for the placement of the chimes at the bottom of the foam core. For half inch chimes, place ¾ inch apart.
|
| Step 8. |
Thread a 12 inch piece of embroider floss through the chime and tie in a knot, then dap a tiny bit of glue to the knot.
|
| Step 9. |
Punch a hole and thread the floss through the foam core, tie the floss in a knot and tape down the tails. Be sure to make all chimes the same height.
|
| Step 10. |
Add double stick tape to both front and back signs and attach to the foam core.
|
| **Submit your project idea to projects@pccrafter.com |
| |
