| |
|
| Instructions: |
|
| Step 1. |
Wind decorative ribbon around entire wreath. Position as desired and glue in place in inconspicuous spots. Secure ends. |
| Step 2. |
Run graphics through Xyron, and adhere to foam-core board. Make sure they do not overlap. Smooth out any bubbles. |
| Step 3. |
Cut out graphics using hot knife. If using a regular craft knife, use an emery board to remove any ragged places around edges. |
| Step 4. |
Place your wreath on a flat surface and position the graphic to decide the best arrangement. Place bow at bottom, decide where any additional embellishments need to go. |
| Step 5. |
Cut tags out of heavy cardstock, (ones in picture where made using Cricut ™ cartridge Bags Tags Boxes and More) or you could also use pre-made tags. Decorate with brads, ribbon, postage stamps or other ephemera, and patriotic sayings. Position these around the wreath. |
| Step 6. |
When desired arrangement has been achieved, take embellishments off one at a time and glue them down to the wreath. Leave flat until glue is dry, then hang and enjoy! |
**Submit your project idea to projects@pccrafter.com |
| |
